Once the truck arrives, the clock is running. Concrete starts to stiffen as soon as it is mixed, and unloading time on site is limited. Almost everything that goes wrong on a small pour comes from the site not being ready.
Before delivery day
- Finish the forms. Forms should be staked, braced and level before you order. Wet concrete is heavy and will push weak forms apart.
- Prepare the base. Pour on firm, compacted, well-drained ground. Never pour on mud, standing water, frozen ground or loose fill.
- Set the reinforcement. Rebar or wire mesh should be in place and supported. If you would rather use fiber in the mix, ask for it when you order.
- Check your measurements. Measure length, width and depth in several places, then run the numbers through the concrete calculator. A slab that is half an inch thicker than planned uses noticeably more concrete.
- Line up help. Concrete cannot wait. Have enough people to move it, level it and finish it. If you have not finished concrete before, consider hiring a finisher.
- Gather the tools. Wheelbarrows, shovels, concrete rakes, a screed board, floats, an edger, a groover, a broom, and curing compound. Rubber boots, waterproof gloves and eye protection for everyone.
Getting the truck in
- Know the truck. A loaded mixer is far heavier, taller and wider than a car or pickup.
- Plan the route. The truck needs a firm, level path wide enough to back in. Look up for power lines, tree limbs and eaves.
- Protect what is in the way. Driveways, sidewalks, curbs, septic tanks, drain fields, wells and buried lines can all be damaged by the weight. If the route crosses any of them, plan to stop the truck short.
- Plan for the gap. If the truck cannot back up to the forms, you will need wheelbarrows, a pump or a conveyor. Our sister company handles pumping and conveying.
- Pick a washout spot. The driver has to rinse the chutes before leaving. Choose a place on your property where a small amount of concrete slurry can go.
When the truck arrives
- Have one person meet the driver and direct the truck.
- Start placing at the far end and work back toward the truck.
- Do not add water at the job to make the concrete easier to move. It weakens the concrete and makes the surface more likely to scale. If you want a wetter mix, ask for a water reducer when you order.
- Do not sprinkle water on the surface while finishing. That also leads to spalling and peeling.
- Wet concrete burns skin. Wash it off right away and change out of clothes that are soaked with it.
- Check and sign the delivery ticket. It records the mix and the time on site.
After the pour
- Cure it. Apply curing compound, or keep the surface covered and moist. Good curing is a large part of how well the surface holds up.
- Give it time. As a general guide, keep foot traffic off for a day or two and cars off for about a week. Full design strength takes around 28 days, longer in cold weather.
- Seal it. Seal outdoor slabs once they have cured for 28 days.
- Keep deicers off. Do not use any deicer on concrete that has not been sealed.
Pouring in very hot or cold weather takes extra planning. See Hot and cold weather concrete.